水泥穩定碎石的強度檢測方法主要包括以下兩種：

　　The strength testing methods for cement stabilized crushed stone mainly include the following two types:

　　一、標準壓實試驗法

　　1、 Standard compaction test method

　　取樣：

　　Sampling:

　　應在拌和場料車內或攤鋪機受料斗內取樣，確保樣品具有代表性。

　　Samples should be taken from the mixer truck or the receiving hopper of the paver to ensure representativeness.

　　取樣時應注意在尚未碾壓的攤鋪層上取到結構層的底部，并且多取幾個斷面，每個斷面在左、中、右各取3個點。

　　When sampling, attention should be paid to taking samples from the bottom of the structural layer on the unrolled paving layer, and taking multiple sections, with 3 points taken from each section on the left, middle, and right.

　　制件：

　　Components:

　　按照規定的壓實度標準制備試件，通常使用標準壓實儀進行壓實。

　　Prepare specimens according to the prescribed compaction standards, usually using a standard compactor for compaction.

　　試件制備過程中應控制密實度、含水量等參數，確保試件質量。

　　During the preparation process of the specimen, parameters such as compactness and moisture content should be controlled to ensure the quality of the specimen.

　　養生：

　　health preservation:

　　試件制備完成后，應進行標準養生，養生條件包括溫度、濕度等應符合規范要求。

　　After the preparation of the test piece, standard curing should be carried out, and the curing conditions including temperature, humidity, etc. should meet the requirements of the specifications.

　　養生期的最后一天，應將試件浸泡在水中，以便進行后續的抗壓強度測試。

　　On the last day of the health preservation period, the specimen should be soaked in water for subsequent compressive strength testing.

　　抗壓強度測試：

　　Compressive strength test:

　　使用壓力機對養生后的試件進行抗壓強度測試，記錄試件的破壞荷載。

　　Use a press to test the compressive strength of the cured specimens and record the failure load of the specimens.

　　根據試件的尺寸和破壞荷載，計算抗壓強度值。

　　Calculate the compressive strength value based on the size of the specimen and the failure load.

　　二、動強度試驗法

　　2、 Dynamic strength test method

　　設備準備：

　　Equipment preparation:

　　使用專用試驗機，該試驗機應具備錘擊和沖擊功能。

　　Use a dedicated testing machine that should have hammering and impact functions.

　　試件準備：

　　Preparation of test specimens:

　　試件的制備與標準壓實試驗法相同，確保試件質量符合規范要求。

　　The preparation of the specimen is the same as the standard compaction test method to ensure that the quality of the specimen meets the specification requirements.

　　動強度測試：

　　Dynamic strength test:

　　將試件放置在試驗機上，進行錘擊和沖擊試驗。

　　Place the specimen on the testing machine and conduct hammer and impact tests.

　　記錄試件的破壞情況，包括破壞荷載和破壞形態。

　　Record the failure condition of the specimen, including the failure load and failure mode.

　　根據試驗結果，評估水泥穩定碎石的動強度性能。

　　Evaluate the dynamic strength performance of cement stabilized crushed stone based on experimental results.

　　注意事項

　　matters needing attention

　　檢測方法的選擇：

　　Selection of detection methods:

　　應根據具體工程要求和實際情況選擇合適的檢測方法。標準壓實試驗法適用于固結較好的水泥穩定碎石，而動強度試驗法適用于各種情況下的水泥穩定碎石。

　　Suitable testing methods should be selected based on specific engineering requirements and actual situations. The standard compaction test method is applicable to cement stabilized crushed stone with good consolidation, while the dynamic strength test method is applicable to cement stabilized crushed stone under various conditions.

　　試件制備的質量控制：

　　Quality control of specimen preparation:

　　試件制備過程中應嚴格控制密實度、含水量等參數，確保試件質量符合規范要求。試件的尺寸、形狀等也應符合測試標準。

　　During the preparation process of the specimen, parameters such as compactness and moisture content should be strictly controlled to ensure that the quality of the specimen meets the specifications. The size, shape, etc. of the test piece should also comply with the testing standards.

　　測試設備的校準和維護：

　　Calibration and maintenance of testing equipment:

　　測試設備應定期進行校準和維護，確保測試結果的準確性和可靠性。

　　Testing equipment should be regularly calibrated and maintained to ensure the accuracy and reliability of test results.

　　安全操作：

　　Safe operation:

　　在進行抗壓強度測試時，應遵守安全操作規程，防止發生意外事故。

　　When conducting compressive strength testing, safety operating procedures should be followed to prevent accidents from occurring.

　　綜上所述，水泥穩定碎石的強度檢測方法主要包括標準壓實試驗法和動強度試驗法。在檢測過程中，應嚴格控制試件制備質量、選擇合適的測試設備和方法，并遵守安全操作規程，以確保測試結果的準確性和可靠性。

　　In summary, the strength testing methods for cement stabilized crushed stone mainly include standard compaction test method and dynamic strength test method. During the testing process, the quality of specimen preparation should be strictly controlled, appropriate testing equipment and methods should be selected, and safety operating procedures should be followed to ensure the accuracy and reliability of test results.

　　本文由 濟南穩定碎石 友情奉獻.更多有關的知識請點擊  http://m.sybloom.com   真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is dedicated by Jinan Stable Gravel Friendship For more related knowledge, please click http://m.sybloom.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.